Manual Loading / Unloading

Steps to load filament

Set the hotend temperature based on the filament you are using, For PLA, a temperature of 220+ ℃ is a good starting point.
2. Wait for the hotend to reach the set temperature
3. Attach the spool to the back spool holder and cut the filament to a 45-degree angle
4. Insert the filament into the back PTFE tube until it reaches the extruder
5. From the printer screen in the filament tab, click on the rear spool holder to highlight the spool, and click on “Load.” When the pop-up appears, manually push the filament.
6. Repeat the extrude process until the old filament is purged out, and the new filament color is clear.

1. Touch the Settings button on the screen interface, then touch the Unload button.
Carefully pull on the filament while also re-spooling it on the filament spool.